Starting A Sat Session; Checking Link Status With Sat (Main Server Only) - Avaya S8 Series Manual

5. Type stop -afcn and press Enter to stop potential call processing on the LSP or ESS
server.
The LSP or ESS server shuts down Communication Manager.
6. Repeat steps
!
CAUTION:
After you complete the upgrade of the primary controller, run save
CAUTION:
translations on the primary controller before you restart Communication
Manager on the LSP/ESS server. The save translations process on the LSP or
ESS server automatically causes the endpoints of the media gateways to
reregister with the primary controller.
For more information on the S8300 LSP, see:
- Installing and Upgrading the Avaya S8300 Server, 555-234-100.
- Installing and Upgrading the Avaya G700 Media Gateway, 03-603333.

Starting a SAT session

To start a SAT session:
1. Open a terminal emulation application, such as MS HyperTerminal.
2. Type 192.11.13.6 5023 and press Enter.
3. Log on as craft or dadmin.
Note:
You must use SAT commands for tasks in
Note:
server only)
SAT

Checking link status with SAT (main server only)

1. Type display communication-interface links and press Enter.
2. Note all administered links.
3. Type status link number and press Enter for each administered link.
4. Check the following fields for the values listed:
Link Status = connected
●
1 through 5 for each LSP or ESS server.
on page 109 through
on page 111.
Checking link status with SAT (main
Checking for translation corruption with the
Preupgrade tasks
Issue 1 May 2009 109