Avaya S8 Series Manual page 54

Upgrading Communication Manager from 1.x, 2.x and replacing S8300A Server with an S8300B/C/D Server
18. If the LSPs (if any) translations
have not synchronized with the
ICC, invoke translation
synchronization.
19. Verify S8300C/S8300D LSP
status (if any).
20. If the S8300C/S8300D LSP's
translations have not
synchronized with the primary
controller, invoke translation
synchronization.
21. Upgrade G700 Media
Gateway firmware
See Installing new firmware on
the G700 Media Gateway
Processor in Chapter 10.
54 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers
Task
LSP mode: On the S8300C/S8300D's primary controller
Steps/Comments
On the ICC's SAT, enter the command
●
save translation lsp.
Ensure that the translation synchronization
●
completed successfully.
Wait several minutes, then check the
timestamp of the LSP's translation files with
the SAT command list
survivable-processor on the ICC.
At the primary controller's SAT prompt,
●
enter list survivable-processor.
The S8300C/S8300D LSP name and IP
address should be listed.
The Translations Updated should match
●
the translations date and time on the
primary controller. To view the primary
controller's translations date and time,
enter list configuration software.
On the primary controller's SAT, enter the
●
command, save translation lsp.
Ensure that the translation synchronization
●
completed successfully.
Wait several minutes, then check the
timestamp of the LSP's translation files with
the SAT command list
survivable-processor on the primary
controller.
Using the Avaya Installation Wizard:
Upgrade G700 firmware
●
Upgrade media module firmware
●
5 of 6