Upgrading firmware on the IPSIs and SIPIs
Upgrade Tasks
Pre-Upgrade tasks
Access the Web Interface
Access the System Management Interface (formerly known as Maintenance Web Interface)
with the following steps.
Note:
If duplicated servers, you must connect to the active server.
Note:
1. If on site, connect to the services port, default 2 [Eth1], on the back of the server.
If off site log in to the server using the IP address of the server.
2. Start the Web browser.
3. If connected directly to the server, type 192.11.13.6 in the Address field to bring up the
logon Web page.
If connected through the network, type in the host name or IP address of the server.
4. Log in as craft or dadmin.
5. When asked whether to suppress alarms, click yes.
Copying files to the server
To copy files to the server:
Copy the following files, as appropriate, from the computer to the server:
License file and Avaya Authentication file
●
Note:
A preupgrade service pack is required for an upgrade from Release 2.x.;
Note:
Preupgrade service pack files, if necessary
●
Postupgrade service pack files if necessary
●
Security update files (used post-upgrade, if necessary)
●
Programmable circuit pack firmware
●
216 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers