Table of Contents
Advertisement
Preupgrade tasks
This section describes the preupgrade tasks required to upgrade an S8700-Series Server
running Communication Manager Release 1.x, 2.x, 3.x, or 4.x of Communication Manager.
Stopping call processing on the LSPs or ESS servers
if being used (main server only)
To stop Communication Manager on an LSP or an ESS server:
1. Connect to the services port on the back of the main server (primary controller).
2. Access the command line interface of the server using telnet and an IP address of
192.11.13.6.
3. Within this telnet session, type telnet IPaddress and press Enter, where IPaddress is
the IP address of the S8300/S8500 LSP or S8500/S8700-series ESS server.
Note:
Use ssh if telnet service is not available.
Note:
The login prompt for the LSP or ESS server appears.
4. Log in to the LSP or ESS server as craft.
5. Type stop -afcn and press Enter to stop potential call processing on the LSP or ESS
server.
The LSP or ESS server shuts down Communication Manager.
6. Repeat steps
!
CAUTION:
After you complete the upgrade of the primary controller, run save
CAUTION:
translations on the primary controller before you restart Communication
Manager on the LSP/ESS server. The save translations process on the LSP or
ESS server automatically causes the endpoints of the media gateways to
reregister with the primary controller.
For more information on the S8300 LSP, see:
- Installing and Upgrading the Avaya S8300 Server, 555-234-100.
- Installing and Upgrading the Avaya G700 Media Gateway, 03-603333.
1
through
5
for each LSP or ESS server.
Preupgrade tasks
Issue 1 May 2009
147
Advertisement
Table of Contents
