Table of Contents
Advertisement
Task
12. Install license file and
authentication file.
See Installing updated license
and authentication files in
Chapter 12.
13. Create a super-user login, if
necessary.
See Creating a super-user
login, if necessary, for R5.0 or
higher in Chapter 12.
14. Verify that the media gateway
has registered with either the
primary controller (LSP mode)
or the S8300C/S8300D (ICC
mode).
ICC mode: On LSPs of the S8300B (if any)
15. Reboot LSPs (if any).
16. Verify LSP translations date
and time (if any).
17. Verify LSP status (if any).
Open a SAT session with either the
●
primary controller (LSP mode) or the
S8300C/S8300D (ICC mode) and enter
list media-gateway.
Verify that the Registered field (Reg?) is set
to y.
Place a test call.
●
At the LSP's SAT prompt, enter reset system
4.
To view the LSP's translations date and time,
enter list configuration software.
ICC mode: On the S8300B
At the ICC's SAT prompt, enter list
●
survivable-processor.
The LSP name and IP address should be
listed.
The Translations Updated should match
●
the translations date and time on the ICC.
To view the ICC's translations date and
time, enter list configuration
software.
Steps/Comments
Issue 1 May 2009
Tasks checklist
4 of 6
63
Advertisement
Table of Contents
