Table of Contents
Advertisement
Upgrading Communication Manager on Avaya S8500-Series Server MAIN/ESS/LSP from R2.x/R3.x/R4.x/
You shut down the server before you upgraded the software.
●
!
Important:
You must be connected to the LSP on which you are upgrading the software.
Important:
You must also restart call processing on any Enterprise Survivable Server (ESS) on which you
stopped call processing before you upgraded software.
Perform the following administration when you connect your laptop to the primary controller
(server) with SSH.
1. Access the command line interface of the server with an SSH client like PuTTY and an IP
address of 192.11.13.6.
2. Type ssh IPaddress, where IPaddress is the IP address of the S8300 or S8500 LSP, or
the S8500 or S8700-series ESS.
3. Log in as craft or dadmin.
4. At the prompt type start -afcn and press Enter to restart call processing on the LSP or
ESS.
5. Repeat for each LSP or ESS.
For more information, see:
- Installing and Upgrading the Avaya S8300 Server, 555-234-100.
- Installing and Upgrading the Avaya G700 Media Gateway, 03-603333.
- Using the Avaya Enterprise Survivable Server (ESS), 03-300428.
Logging off all administration applications
When you complete all the administration, log off all the applications that you used.
Registering Communication Manager
Follow standard procedures to register the new software.
138 Upgrading Avaya Aura™ Communication Manager on Avaya S8xxx Servers
Advertisement
Table of Contents
