Tone-Burst Frequency; Default Tone Value; Default Sq Value - Alinco DR-B185T Instruction Manual

ON: Sets the BCLO setting to ON.
▼
OFF: Sets the BCLO setting to OFF.
▼
3. Press the push-button rotary knob.
The unit will go back to menu mode.
„ „

Tone-Burst Frequency

This is to access Tone-Burst repeaters which require a certain pitch of
audible tone to activate "sleeping" repeaters. Usually, a repeater system
does not require the tone once the repeater is activated.
1. Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "16".
The current setting will appear on the display.
The default setting is [TB .1750].
2. Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
1750 (1750Hz), 2100 (2100Hz), 1000 (1000Hz), 1450 (1450Hz)
▼
3. Press the push-button rotary knob.
The unit will go back to menu mode.
„ „

DEFAULT TONE VALUE

Set the TONE value displayed by operating the [TS/DCS/LOCK] key for
the first time after turning on the power. Select one out of 39 types of
standard tones.
1. Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "17".
The current setting will appear on the display.
PARAMETER SETTING MODE
The default setting is [T.67.0 ] (67.0Hz).
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
67.0Hz to 250.3Hz (See the table below).
▼
• 250.3Hz is followed by 67.0Hz.
• 67.0Hz comes before 250.3Hz.
3. Press the push-button rotary knob.
The unit will go back to menu mode.
„ „

DEFAULT SQ VALUE

Set the SQ value which is displayed by operating the [TS/DCS/LOCK]
key for the first time after turning on the power. Select one out of 39
types of standard tones.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "18".
The current setting will appear on the display.
The default setting is [T.67.0 ] (67.0Hz).
2. Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
67.0Hz to 250.3Hz (See the table of the "DEFAULT TONE
▼
VALUE").
7
24