Table of Contents
Advertisement
Please hold the microphone approximately 2.5-5.0cm from your lips
then speak into the microphone in your normal speaking voice.
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Transmitting Tone BURST TONE
Press and hold [PTT] key, then press Microphone [
transmit current selected tone-burst tone. Pre-programming is necessary.
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone
key in front panel or press Mic's
selected DTMF/2Tone/5Tone optional signaling. Pre-programming is
necessary.
, and
] key to
key or press
key to transmit pre-stored and
Basic Operations
MEMORY CHANNEL PROGRAMMING
1.
Under frequency mode (VFO), turn
Dial to select the desired frequency or
input frequency by MIC's numeric keys.
2.
Press
key to enter CTCSS/DCS
signaling setup, turn Main Dial to select
the desired signaling. See P.13 for
details.
3.
Press
key, LCD appears
and current channel number,
is empty.
4.
Turn
Main Dial to select the desired channel number to store.
5.
Press
key,
,
icon and channel number disappears and
beep sounds twice.
6.
Press
V/M key again to confirm that the memory channel is properly
stored.
MEMORY CHANNEL DELETING
1.
Under Memory mode, turn
deleted.
2.
Press
key and
key together, current memory will be
deleted beep sounds.
icon flashing means current memory is
deleted.
5
Main
,
icon
icon flashing means current channel
Main Dial to select channel to be
12
Advertisement
Table of Contents
