Chapter 6: Replacing Assemblies
To remove and replace the LS120 floppy disk drive
To remove and replace the LS120 floppy disk drive
Use this procedure to remove and replace the floppy disk drive. When necessary, refer to other
removal procedures.
Disconnect the power cable and remove the top sleeve.
1
Using a T10 driver remove the adapter board from the LS120 disk drive.
2
Using a T8 driver remove the two side screws holding the LS120 disk drive in place.
3
Slide the LS120 disk drive through the front frame and remove.
4
Figure 6-22
Removing the Floppy Disk Drive Screws
To replace the LS120 disk drive, reverse the above procedure with a new disk drive.
5
6–20