Hard Drive Partitioning And Use - Agilent Technologies E6630A Getting Started Manual

3
Test Set Operating System

Hard Drive Partitioning and Use

The drive is partitioned into 3 sections: C:, D: and E:
• The C: partition contains the Windows operating system and software installed by
• The D: partition is reserved for data storage. The User Accounts that are configured
• The E: partition is reserved for Agilent's use. The primary use of the E: drive is for
64
Agilent. This is an Open System which means you can install additional software,
and these should be installed on the C: drive. However, only a limited set of software
applications are tested for use with the Agilent measurement software. The
installation and/or use of other software is not warranted, and could interfere with the
operation of the measurement software. If test set repair is ever needed, the Agilent
version of the C: drive is the only part of the test set software that is restored by the
Agilent Recovery process. You must reload any other software that you have added
in the test set.
by Agilent have their My Documents folder mapped to the D: drive. This is for the
convenience of backing-up the measurement data. You should always back-up the
data on the D: drive to an external device. This allows you to restore the data if you
ever need to replace the hard drive.
housing the Calibration and Alignment data. Do not change or overwrite the files on
this drive. This could cause your test set to not meet specifications, or even to stop
functioning correctly. Do not use this drive for data storage. It is also recommended
that you back up the contents of this drive by using the factory calibration data
backup utility.
Getting Started Guide