Lower-Mow/Raise Switches; Enable/Disable Switch - Toro Reelmaster 5100-D Service Manual

Lower-Mow/Raise Switches (Joystick)
The Lower-Mow/Raise Control has two (2) normally
open (NO) switches, one for the Lower-Mow function
and one for the Raise function. Each switch is normally
open and closes when the joystick is moved (Fig. 15).
Test each switch by disconnecting the wiring connector
from the switch and connecting a continuity tester
across the two terminals of the switch being tested.
Lower-Mow Switch
With the engine turned off, move the joystick forward,
then allow it to return to neutral while watching the
continuity tester. There should be indications that the
switch is opening and closing. With the joystick in the
neutral position there should be no continuity across the
terminals.
Lower-Mow Switch
With the engine turned off, move the joystick toward the
rear, then allow it to return to neutral while watching the
continuity tester. There should be indications that the
switch is opening and closing. With the joystick in the
neutral position there should be no continuity across the
terminals.

Enable/Disable Switch

Test the Enable/Disasble switch by disconnecting the
wires from the switch and connecting a continuity tester
across the terminals of the switch.
With the switch in the DISABLE position, the tester
should show no continuity. With the switch in the EN-
ABLE position, the tester should show continuity.
®
Reelmaster 5100-D
1. Lower-mow switch
1
Page 5 - 21
1
Figure 15
2. Raise switch
Figure 16
1. Enable/Disable switch
2
Testing