Table of Contents
Advertisement
Step 4.
Remove the air baffle (see "Removing the air baffle" on page 106).
Step 5.
Touch the static-protective package that contains the DIMM to any unpainted metal surface on the
outside of the server. Then, remove the DIMM from the package.
Step 6.
Carefully open the retaining clips on each end of the DIMM connector.
Figure 44. DIMM installation
Step 7.
Turn the DIMM so that the alignment slot aligns correctly with the alignment tab.
Step 8.
Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends
of the DIMM connector (see "System-board internal connectors" on page 22 for the locations
of the DIMM connectors).
Step 9.
Firmly press the DIMM straight down into the connector by applying pressure on both ends of the
DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly
inserted; open the retaining clips, remove the DIMM, and then reinsert it.
Step 10. Reconnect the power cords and any cables that you removed.
Step 11. Replace the air baffle (see "Replacing the air baffle" on page 107).
Note: Close all the retaining clips even for slots without DIMMs installed before replacing the
air baffle.
Step 12. Reinstall the cover (see "Replacing the cover" on page 105).
Step 13. Turn on the peripheral devices and the server.
Removing a PCI riser-card assembly
Use this information to remove a PCI riser-card assembly.
Note: PCI riser-card brackets must be installed even if you do not install an adapter.
To remove a PCI riser-card assembly, complete the following steps:
120
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Alignment
slot
DIMM
Retaining
clip
Alignment tab
Advertisement
Table of Contents
Troubleshooting
