Replacing The Hot-Swap Hard Disk Drive; Backplane - Lenovo System x3100 M4 Installation And Service Manual

Configuration cable
10. Remove the four screws that secure the SAS/SATA hard disk drive backplane to the drive cage.
Screws
11. Lift the hot-swap backplane out of the lower lip on the drive cage and set it aside.
12. If you are instructed to return the SAS/SATA hard disk drive backplane, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Replacing the hot-swap hard disk drive backplane
This procedure applies only to the 5U server model with hot-swap power supplies (Model name: 2582-F4x).
To install the hard disk drive backplane on the 5U server model with hot-swap power supplies (Model name:
2582-F4x), complete the following steps.
1. Place the bottom edge of the hot-swap hard disk drive backplane in the lower lip of the drive cage.
2. Connect the power, signal and configuration cables to the hard disk drive backplane.
Note: Make sure that Port 1 on the hardware ServeRAID is connected to Port 1 on the backplane.
Likewise, Port 0 on the hardware ServeRAID should be connected to Port 0 on the backplane.
System x3100 M4 Installation and Service Guide
198
Power cable
Signal cables