Installing A Network Card; Figure 8-17 Installing A Network Card In The Printer - Tektronix Phaser 550 Service Manual

8
FRU Disassembly/Assembly

Installing a network card

8-28 Phaser 550 Color Printer
Note
EtherTalk and LocalTalk protocols require you to attach the Ethernet
cable to the printer with the printer powered off. After connection,
turn on the printer. During the printer's boot-up process, the
printer's network node address is resolved with the network.
1. Power down the printer. Do not unplug the printer; this preserves a
ground path to dissipate static charges.
2.
Remove the network card cover plate from the rear panel of the
printer.
3. Slide the network card into the card slot and firmly push it in place.
Secure it in place with two screws.
Token Ring network card.
printer's Token Ring network card is set for the speed of the token
ring network. Not installed, set the card for 16 Mbps (the most
common configuration); installed, set the card for 4 Mbps.
4. Connect the appropriate host interface cable to the network card.
5.
Turn on the printer and print the startup page. It lists the installed
memory and options.

Figure 8-17 Installing a network card in the printer

Ensure the transmission speed jumper on the
Network card
9013-43