8
FRU Disassembly/Assembly
Cartridge selector/eject unit (right door)
8-8
Phaser 550 Color Printer
1.
Remove the right-side covers as explained in the earlier topic, "Right
side covers (front, rear and lower)" on page 8-5.
2.
Disconnect the cartridge selector/eject unit's wiring harness.
3.
Remove the E-ring and bushing from each end of the cartridge
selector/eject unit. Remove the third E-ring from the cartridge
selector/eject unit's shaft.
4.
Unlatch the cartridge selector/eject unit and lower it half-way down
to relieve spring pressure. Remove the shaft and then remove the
cartridge selector/eject unit.
Figure 8-4 Removing the cartridge selector/eject unit
Remove E-ring
Remove E-ring and
bushing from each
end of the cartridge
selector/eject
unit
Cartridge selector/
eject unit
(right door)
Disconnect
wiring harness
9013-30