2
Installing the Printer and Drivers
Connecting the optional CopyStation to the printer
2-12
Phaser 550 Color Printer
Perform this procedure if the customer has purchased a CopyStation.
Otherwise, continue to the next procedure. The CopyStation may be
"daisychained" with one or more SCSI drives being used for font storage. Be
sure that each SCSI device uses a unique SCSI address (0 through 4). Installing a
CopyStation is fully explained in the Phaser CopyStation User Manual.
1.
Make sure that the printer and the SCSI disk drive are turned off.
2.
Attach the CopyStation's SCSI cable to the printer's SCSI port.
3.
Attach the other end of the SCSI cable to the CopyStation's SCSI port.
Figure 2-3 Connecting a CopyStation to the Phaser 550
Note
The CopyStation uses two SCSI address: 5 and 6. Make sure that
any connected SCSI hard drive does not use these addresses.
4.
Turn on the CopyStation (and any hard drives) first, and then turn on
the printer.
5.
Refer to the Phaser CopyStation User Manual for details.
CopyStation
SCSI cable
9013-59