Tektronix Phaser 550 Service Manual page 201

Table 9-2 Status code meanings (cont'd.)
Status Front Binary
State Panel
Hex 7 . . .
Status - 14
Process
Unit Error
Status
Status - 14 01 0000 0001
Example
Status - 15
Process
Unit Error
Status
Meaning/Description
0
This status shows the details of the printing process errors identified in the Status - 0
Bit 1, Status - 1 Bit 1, and Status - 2 Bit 6.
0. Odd parity.
1. 1= Toner cartridge unit movement error. Refer to Status - 25 for details.
0 = Toner cartridge movement is normal.
2. 1 = Fuser error. Refer to Status - 22 for details.
0 = No fuser error.
3. 1 = Fan motor error. Refer to Status - 16 for details.
0 = Fans are working normally.
4. 1 = Toner bin is full. See Status - 43 for details.
0 = The toner bin is not full.
5. 1 = Positioning error has occurred. Refer to Status - 24 for details.
0 = No positioning error.
6. 1 = Charger error caused by an over current condition in the power supply to the
charger.
0 = No charger error.
7. 1 = A communication error has occurred.
0 = There is no communication error.
The movement of the toner cartridges are normal.
The operation of the fuser is normal.
The operation of the fan motors is normal.
The waste toner bin is not full.
The positioning of the photoconductive belt and accumulator belt is operating normally.
The charger unit is operating normally.
There is no communication error.
This status shows paper/transparency discrepancies, manual feed jams and paper
conditions in the selected trays, manual feed, or the output tray. This also relates to the
detailed status of Status - 0 Bit 1, and Status - 1 Bit 4.
0. Odd parity.
1. 1= The output tray is full.
0 = The output tray is not full.
2. 1 = No media in the manual feed slot.
0 = There is media in the manual feed slot.
3. 1 = The selected tray is empty
0 = The selected tray is not empty.
4. 1 = There has been a manual paper feed jam detected at warm-up and initialization. A
Jam is defined when the aligning sensor is active (paper in the path) during warm-up
and initialization. Reset by removing paper from manual feed tray.
0 = No manual feed jam was not detected at warm-up
5. 1 = The manual paper feed has not detected a jam. A jam occurs when paper does not
reach the aligning sensor within 1.5 seconds after picking paper from the manual feed
tray. This bit is reset by removing paper from manual feed tray.
0 = No manual feed jam has occurred
6. 1 = Transparency is detected in the paper tray or paper has been detected in the
transparency tray.
0 = Paper in paper tray or transparency in transparency tray
7. 1 = A communication error has occurred.
0 = There is no communication error.
Checks and Adjustments
Service Manual 9-19
9