Charger sensor board
Engine control
board
Figure 8-9 Removing the engine control, engine driver and charger sensor boards
1.
Remove the upper rear cover as explained in the earlier procedure,
"Upper rear cover" on page 8-2.
2.
Remove the engine control board as explained in the previous
procedure, "Engine control board" on page 8-14.
3.
Disconnect the wiring harnesses leading to the charger sensor board.
4.
Remove the two screws securing the board in place. Remove the
charger sensor board.
Charger sensor
board
Engine control
board bracket
Engine driver
board
FRU Disassembly/Assembly
Engine driver
board bracket
9013-35
Service Manual
8-15
8