Pre-exposure lamp
Pre-transfer lamp
Toner auto-density sensor
1.
Turn off the printer. Remove the imaging unit.
2.
Remove the screw securing the pre-exposure lamp in place.
3.
Disconnect the pre-exposure lamp's wiring harness. Remove the
lamp.
1.
Turn off the printer. Remove the imaging unit.
2.
Remove the E-ring securing the front end of the cleaning cam roller.
Move the front end of the roller out of the way.
3.
Remove the screw securing the pre-transfer lamp in place.
4.
Disconnect the pre-transfer lamp's wiring harness. Remove the lamp.
1.
Turn off the printer. Remove the imaging unit.
2.
Remove the two screws securing the auto-density sensor in place.
3.
Disconnect the sensors's wiring harness. Remove the auto-density
sensor.
FRU Disassembly/Assembly
Service Manual
8
8-21