Testing motor resistances
Required tools
#1 Phillips screwdriver
VOM
With a VOM set for measuring resistance, test each motor's windings for its
correct resistance. Rotate the motor's drive shaft slowly while taking the
measurement.
Table 6-1 Motor and solenoid resistances
Motor or solenoid
Main motor
Paper feed motor
Toner cartridge drive motor
Toner cartridge selector cam
motors
Transfer roller clutch
Aligning roller clutch
Cleaning (accumulator belt)
blade solenoid
Connector
Resistance (approximately)
CN313
25 ohms between pins 1 and 2, pins 1
and 3, pins 2 and 3.
350 ohms between pins 4 and 5, pins 6
and 7, pins 8 and 9.
CN306
5 ohms between pins 1 and 2.
300 ohms between pins 3 and 5,
pins 3 and 6, pins 4 and 5, pins 4 and 6.
350 ohms between pins 3 and 4, and
between pins 5 and 6.
CN305
1.5 ohms between pins 1 and 2.
10 kohm between pins 3 and 5.
CN308
50 ohms between pin 22 (+24 V) and pins
20 (cyan motor), 18 (magenta motor),
16 (yellow motor) and 14 (black motor).
CN606
80 ohms
CN605
150 ohms
CN302
120 ohms
Troubleshooting
Service Manual
6-7
6