Configuring A Novell Netware Server For The Printer - Tektronix Phaser 550 Service Manual

2
Installing the Printer and Drivers
Configuring a Novell NetWare server for the printer
2-34 Phaser 550 Color Printer
If communication to the serial port uses 7 data bits, the value for xs
changes as follows. All other set up parameters remain the same.
px:\
:br#9600:rw:\
:fc#00000374:fs#00000003:\
:xc#0:xs#0040040:\
:mx#0:sf:sh:\
:sd=/var/spool/px:\
:if=/var/spool/px/if:\
:lp=/dev/ttya:
5.
To print a PostScript file, type:
lpr -Ppx filename
This is a brief overview of the steps you follow to configure a Novell NetWare
file server and set up print queue to support the printer on a Novell network.
The Phaser Share Software User Manual gives the step by step procedure you
follow to perform this configuration. There are two methods, each using a
different utility program, you can use to configure the file server and set up
print queues. In brief, this is what you will do:
1. Load the utility Advanced Configuration Tool (ACT) onto the file
server through a workstation.
2.
Log on to a file server as supervisor with supervisor privileges.
3. Run ACT and select Quick Configuration.
4. At this point you will be able to "see" a list of available printers. The
printer's print server name is displayed. The default name is
TEKxxxxxx where xxxxxx is the last six hex digits of the printer's
Ethernet address. Select the printer. If the printer is not displayed,
refer to the Novell NetWare Configuration topic in the Phaser Color
Printers Network Manual.
5. Select a file server for the printer to service.
6. Select a queue for the printer to service or create a new queue.
7.
Save the configuration.
8. Following this, you can select another file server and create more
queues for the printer to service. You can have a total of 32 queues on
up to eight file servers.
9.
After all file servers have been configured, save the configuration file
and restart the print server.