Network Card - Tektronix Phaser 600 Service Manual

Network card

6.
Reinstall the Extended Features SIMM (if removed) and RAM
SIMM(s).
7. Reinstall the image processor board into the printer.
8. Reconnect the host interface cables. Turn on the printer and print the
startup page.
1.
Turn off the printer. Leave the power cord plugged in to provide a
discharge path for static electricity.
2. Unscrew the two thumbscrews securing the network card to the back
of the image processor board.
3.
Slide out the network card.
Image processor board
Edge guide
Figure 8-54 Removing the network card
Reverse these steps to install the network card.
Network card Thumbscrews
9482-73