Table of Contents
Advertisement
®
xStack
Parameter
Group Address
Group Mask
RP Address
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
PIM Register Checksum Settings
This window is used to configure the IP address of the RP, for which the data part will be included when calculating
the checksum for registering packets to the RP. The data part is included when calculating the checksum for a PIM
register message to the RP on the first hop router.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
Register Checksum Settings, as shown below:
The fields that can be configured are described below:
Parameter
RP Address
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
PIM Neighbor Table
This window is used to display the current PIM neighbor router table.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
Neighbor Table, as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Description
Enter the multicast group address for this Static RP. This address must be a class D
address.
Enter the mask for the multicast group address stated above.
Enter the IP address of the Rendezvous Point.
Figure 6-70 PIM Register Checksum Settings window
Description
Enter the IP address of the RP for which the data part will be included when calculating
checksum for registering packets to the RP.
Figure 6-71 PIM Neighbor Table window
Description
Enter the name of the IP interface for which you want to display the current PIM neighbor
routing table.
218
Advertisement
Table of Contents
