Pim Register Checksum Settings; Pim Neighbor Table - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Group Address
Group Mask
RP Address
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.

PIM Register Checksum Settings

This window is used to configure RP addresses. The data part is included when calculating the checksum for a PIM
register message to the RP on the first hop router.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
Register Checksum Settings, as shown below:
The fields that can be configured are described below:
Parameter
RP Address
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.

PIM Neighbor Table

This window is used to display the current PIM neighbor router table.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
Neighbor Table, as shown below:
The fields that can be configured are described below:
Parameter
Description
Enter the multicast group address for this Static RP. This address must be a class D
address.
Enter the mask for the multicast group address stated above.
Enter the IP address of the Rendezvous Point.
Figure 6-110 PIM Register Checksum Settings window
Description
Enter the IP address of the RP for which the data part will be included when
calculating checksum for registering packets to the RP.
Figure 6-111 PIM Neighbor Table window
Description
264