Removing The Main Drive Motor And Gear Box - Kodak X-Omat 480 RA Service Manual

Removing the Main Drive Motor and Gear Box

For this procedure the processor must be deenergized. See page 1-7. In addition, the TOP
COVER and DRIVE SIDE ACCESS PANEL must be removed from the processor. See pages 1-3
through 1-5 for instructions, if necessary. Also, make sure that the water supply to the processor
is shut off for this procedure.
[1] Remove the FILTER BEZEL and SPLASH
GUARD.
[2] Disconnect the WATER HOSE from the
MOTOR MOUNT BRACKET.
[3] Loosen the 2 MOTOR BRACKET MOUNTING
BOLTS.
[4] Remove the CHAIN from the SPROCKET.
[5] Remove the SPROCKET from the MOTOR.
[6] Disconnect the MOTOR CONNECTOR J30.
[7] Remove the MOTOR and BRACKET
ASSEMBLY from the processor.
Hold the MOTOR when removing the 4
MOTOR BRACKET MOUNTING
SCREWS so that the MOTOR does
not fall.
[8] Remove the 4 MOTOR BRACKET
MOUNTING SCREWS that hold the MOTOR
and GEAR BOX to the BRACKET.
3-4
IMPORTANT
[9] Install the new MOTOR and/or GEAR BOX to
the BRACKET using the 4 MOTOR BRACKET
MOUNTING SCREWS removed previously.
[10] Install all parts removed in previous steps and
make all necessary connections.
[11] Energize the processor by moving the MAIN
CIRCUIT BREAKER, CB1, to the ''I'' position.
[12] Check that all cycle speeds are operating
correctly and not producing any error codes.
[13] Deenergize the processor by moving the
MAIN CIRCUIT BREAKER, CB1, to the ''O''
position.
246616