Removing The Developer And Fixer Drain Valves - Kodak X-Omat 480 RA Service Manual

Removing the Developer and Fixer Drain Valves

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-7. In
addition, the TOP COVER, both SIDE
ACCESS PANELS, and the
FEED-END, MIDDLE ACCESS PANEL
must be removed from the processor.
See pages 1-3 through 1-5 for
instructions, if necessary. Also make
sure that the water supply to the
processor is shut off for this procedure.
[1] Drain the DEVELOPER and FIXER TANKS by
opening the DEVELOPER and FIXER DRAIN
VALVES on the FEED END of the processor.
246616
FIXIER-
ABLASSHAHN
ENTWICKLER-
ABLASSHAHN
Figure 5-20 Opening the Developer and
Fixer Drain Valves
H108_0004CCF
H108_0004CA
5-23