Table of Contents
Advertisement
Removing the Developer or Fixer Heater
For this procedure the processor must be deenergized. See page 1-7. In addition, the
FEED-END, MIDDLE and the DRIVE SIDE ACCESS PANELS must be removed from the
processor. See pages 1-3 through 1-5 for instructions, if necessary.
[1]
Either—
(a)
Drain the DEVELOPER and/or FIXER TANK by opening the DEVELOPER and/or FIXER DRAIN
VALVES on the FEED END of the processor or,
(b)
Place CLAMP TL-2170 on the DEVELOPER or FIXER TUBES leading to and from the
THERMOWELL.
[2]
Disconnect DEVELOPER HEATER CONNECTOR P8 or FIXER HEATER CONNECTOR P6 from the
ELECTRICAL BOX.
[3]
Remove the HEATER from the THERMOWELL.
[4]
Check that the HEATER LOCATOR is positioned in the THERMOWELL 13.9 cm (5.5 in.) from the end
opposite the HEATER.
Overtightening of the HEATER may cause damage to the THERMOWELL.
[5]
To install the new HEATER, use SILASTIC SEALANT RTV 102 TL-3230 or equivalent. Tighten by hand
plus 1/2 turn.
[6]
Make the necessary connections.
[7]
Remove CLAMPS TL-2170.
5-6
IMPORTANT
A small amount of DEVELOPER or FIXER will spill.
HEATER LOCATOR
Figure 5-5 Checking Heater Locator Positioning
THERMOWELL
HEATER
LOCATOR
H108_0120BCA
H108_0120BA
246616
Advertisement
Table of Contents
