Resilient G Roller (Developer And Fixer Racks); Removing And Installing The G Roller - Kodak X-Omat 480 RA Service Manual

Resilient G Roller (Developer and Fixer Racks)

Removing and Installing the G Roller

[1] At the top of the RACK ASSEMBLY, remove the SPRING from both ends. See Figures 2-5 and 2-6.
[2] Remove the SCREWS, WASHERS, GEAR, SPACERS, and BEARINGS from the outside of both SIDE
PLATES.
[3] Rotate the SHAFT so that the KEYWAY is in the up position. See Figure 2-6.
[4] Pull the ROLLER to the non-drive side and remove the KEY from the SPROCKET.
[5] Pull the SHAFT to the non-drive side to be free of the SIDE PLATE.
[6] Remove the THRUST WASHER, SPROCKET, and SPACER.
[7] Continue to pull the SHAFT to the non-drive side.
[8] Remove the ROLLER.
[9] Reverse the procedure to assemble.
SIDE
PLATE
non drive
side
Figure 2-5 Removing the Resilient G Roller from the Developer or Fixer Rack
246616
DRIVE
ROLLER
SIDE
PLATE
SPRING
drive side
H048_0045DCA
H048_0045DA
2-5