Table of Contents
Advertisement
Removing the Dryer Drive Belt
For this procedure the processor must be deenergized. See page 1-7. In addition, the TOP
COVER and RECEIVING-END ACCESS PANEL must be removed from the processor. See
pages 1-3 through 1-5 for instructions, if necessary.
[1]
Remove:
• Outer AIR TUBES
• ROLLER ASSEMBLIES
• Inner AIR TUBES.
[2]
To release the tension on the BELT, remove the SPRING from the TENSION ROLLER ARM. See
Figure 4-8 on page 4-9.
[3]
Remove the DRYER DRIVE BELT.
[4]
Install:
• New DRYER DRIVE BELT
• SPRING on the TENSION ROLLER ARM
• Inner AIR TUBES
• ROLLERS
• Outer AIR TUBES.
[5]
If the DRYER DRIVE BELT does not remain in the middle of the DRIVE PULLEY, do the Dryer Belt
Tracking Adjustment on page 4-14.
4-10
IMPORTANT
ROLLER ASSEMBLY
AIR TUBE
Figure 4-9 Removing Air Tubes and Rollers
H108_0237BCB
H108_0237BA
246616
Advertisement
Table of Contents
