Table of Contents
Advertisement
Removing the Dryer Drive Pulley
For this procedure the processor must be deenergized. See page 1-7. The TOP COVER must
be removed from the processor. See pages 1-3 through 1-5 for instructions, if necessary.
[1]
Remove the SPRING from the TENSION
ROLLER ARM.
[2]
Move the DRYER DRIVE BELT off the DRIVE
PULLEY.
[3]
Remove the PIN from the DRIVE PULLEY.
[4]
Remove the DRIVE PULLEY.
[5]
Install a new PULLEY and PIN.
[6]
Place the DRYER DRIVE BELT onto the
DRIVE PULLEY.
[7]
Install the SPRING on the TENSION ROLLER
ARM.
[8]
If the DRYER DRIVE BELT does not remain
in the middle of the DRIVE PULLEY, do the
Dryer Belt Tracking Adjustment on page 4-14.
246616
IMPORTANT
DRIVE
PULLEY
Figure 4-8 Removing the Dryer Drive Pulley
SPRING
(Not Shown)
DRYER
TENSION
DRIVE BELT
ROLLER ARM
H108_0278CCA
H108_0278CA
4-9
Advertisement
Table of Contents
