Table of Contents
Advertisement
Crossover Assemblies
Adjusting the Side Plates
[1]
Remove the DETECTOR CROSSOVER
ASSEMBLY from the processor.
[2]
Set the DETECTOR CROSSOVER
ASSEMBLY on a flat surface.
[3]
Loosen the SCREWS of the TIE RODS.
[4]
Check the SIDE PLATES for squareness
against the flat surface.
[5]
Tighten the SCREWS.
The GUIDE SHOES are not adjustable.
[6]
Check that the longer TIPS of the GUIDE
SHOES are in the direction of the film travel.
[7]
Do this procedure for each CROSSOVER
ASSEMBLY.
SIDE PLATE
Figure 2-3 Adjusting the Side Plates of the Detector Crossover Assembly
246616
NOTE
GUIDE SHOE
LONG
TIP
Figure 2-2 Checking the Guide Shoes
GUIDE SHOE
SIDE PLATE
SHORT
TIP
H048_0155CCA
H048_0155CA
H048_0157BCC
H048_0157BA
2-3
Advertisement
Table of Contents
