Removing the Tank Assembly
IMPORTANT
For this procedure the processor must
be deenergized. See page 1-7. In
addition, the TOP COVER, both SIDE
ACCESS PANELS, and the
FEED-END, LOWER ACCESS PANEL
must be removed from the processor.
See pages 1-3 through 1-5 for
instructions, if necessary. Also make
sure that the water supply to the
processor is shut off for this procedure.
[1]
Drain the DEVELOPER and FIXER TANKS by
opening the DEVELOPER and FIXER DRAIN
VALVES on the FEED END of the processor.
246616
FIXER
DRAIN VALVE
DEVELOPER
DRAIN VALVE
Figure 5-13 Opening the Developer
and Fixer Drain Valve
H108_0004CCC
H108_0004CA
5-15