Removing the Drive Shaft Assembly
For this procedure the processor must be deenergized, and the TOP COVER and
RECEIVING-END ACCESS PANEL must be removed from the processor. See pages 1-3
through 1-7 for instructions, if necessary.
[1]
Remove the FILTER BEZEL and SPLASH
GUARD.
[2]
Remove the SPRING from the TENSION
ROLLER ARM.
[3]
Move the DRYER DRIVE BELT off the DRIVE
PULLEY.
3-6
IMPORTANT
DRIVE
PULLEY
Figure 3-3 Removing the Spring
SPRING
(Not Shown)
DRYER
TENSION
DRIVE BELT
ROLLER ARM
H108_0278CCA
H108_0278CA
246616