Removing The Blower Impeller Shaft - Kodak X-Omat 480 RA Service Manual

Removing the Blower Impeller Shaft

For this procedure the processor must be deenergized. See page 1-7. In addition, the DRIVE
SIDE ACCESS PANEL must be removed from the processor. See pages 1-3 through 1-5 for
instructions, if necessary.
[1] Remove the BLOWER MOTOR COVER from
the BLOWER DRIVE MOTOR.
[2] Remove the BLOWER DRIVE BELT.
[3] Loosen the 2 DRIVE PULLEY SETSCREWS.
[4] Remove the BLOWER DRIVE BELT PULLEY.
[5] Loosen:
• INNER BEARING SETSCREWS
• OUTER BEARING SETSCREWS.
[6] Remove the SCREWS and the HOUSING
COVER. See figure 4-4.
[7] Remove the IMPELLER SHAFT and
IMPELLER ASSEMBLY.
[8] Loosen the IMPELLER SETSCREWS.
[9] Remove the IMPELLER ASSEMBLY from the
IMPELLER SHAFT.
[10] Install a new IMPELLER ASSEMBLY onto the
IMPELLER SHAFT.
[11] Install all parts removed and tighten the
SCREWS.
[12] For correct operation of the BLOWER DRIVE
BELT, align the BLOWER DRIVE MOTOR
and the BLOWER DRIVE BELT PULLEYS.
4-4
IMPORTANT
INCORRECT
Figure 4-3 Removing the Blower Motor Cover
CORRECT
DRIVE PULLEY
SETSCREWS
BLOWER
DRIVE
BELT
BLOWER
DRIVE
MOTOR
MOTOR
MOUNTING
BOLT (3)
H108_0074CCA
H108_0074CA
246616