Table of Contents
Advertisement
Adjusting the Brightness for the 200 Circuit Board Display (Control Panel)
The 200 CIRCUIT BOARD DISPLAY
(CONTROL PANEL) is located on the
side of the processor which is in the
darkroom. To prevent fogging of the
film, check that the brightness of the
display is no brighter than is necessary
to read the display.
[1]
Insert a POTENTIOMETER ALIGNMENT
TOOL through the ACCESS HOLE in the
CONTROL PANEL and into the
POTENTIOMETER.
[2]
Rotate the POTENTIOMETER clockwise
brighten the display. Rotate the
POTENTIOMETER counterclockwise
dim the display.
[3]
Move the darkroom light switch to the ''OFF''
position.
[4]
Adjust the POTENTIOMETER until the
brightness of the display is no brighter than is
necessary for you to read the indicators
shown, yet it is not bright enough to fog film.
246616
to
to
Figure 6-12 Adjusting the Brightness of
POTENTIOMETER
ACCESS HOLE
CONTROL PANEL
the 200 Board Display
H108_0229CCC
H108_0229CA
6-15
Advertisement
Table of Contents
