Removing The Developer Filter - Kodak X-Omat 480 RA Service Manual

Removing the Developer Filter

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-7. In
addition, the TOP COVER must be
removed from the processor. See
pages 1-3 through 1-5 for instructions,
if necessary.
[1] Remove the FILTER CAP.
[2] Remove and discard the DEVELOPER
FILTER.
[3] Install the new DEVELOPER FILTER.
[4] Install and tighten the FILTER CAP.
[5] Energize the processor.
[6] Check the FILTER CANISTER for leaks.
246616
DEVELOPER
FILTER
Figure 7-7 Removing the Developer
Cap and Filter
FILTER
CAP
H108_0068ACA
H108_0068AA
7-9