Table of Contents
Advertisement
Removing the 5600 Circuit Board Assembly
For this procedure the processor must be deenergized. See page 1-7. In addition, the TOP
COVER must be removed from the processor. See page 1-3 for instructions, if necessary.
[1]
Move the MAIN CIRCUIT BREAKER CB1 to the ''O'' position to deenergize the processor.
[2]
Remove:
• 2 SCREWS
• 2 WASHERS
• 2 LOCK WASHERS
• STRAIN RELIEF
[3]
Disconnect CONNECTOR P/J5601. See Figure 6-17.
[4]
Remove the 5600 CIRCUIT BOARD ASSEMBLY.
[5]
Reverse the procedure to install a new 5600 CIRCUIT BOARD ASSEMBLY.
[6]
Do the procedure to adjust the ENTRANCE DETECTOR SWITCHES. See page 6-3.
246616
IMPORTANT
Possible damage from electrostatic discharge.
6-23
Advertisement
Table of Contents
