Turnaround Assembly
Disassembling the Turnaround Assembly
Figure 2-8 shows a WASH RACK; however, the procedure is the same for the disassembly of all
RACKS.
[1]
Loosen the 4 ADJUSTING SCREWS.
[2]
Remove the 4 HOLDING SCREWS.
[3]
Open the CHAIN.
[4]
Remove the top section of the RACK from the TURNAROUND ASSEMBLY.
[5]
Remove:
• EXIT GUIDE SHOE and the 2 BRACKETS
• 2 SPRINGS and LOCKING PLATE from the TURNAROUND
• Both ''A'' ROLLERS.
[6]
From the non-drive side, pull the SHAFT from the ''B'' ROLLER.
[7]
Remove the TURNAROUND ASSEMBLY.
246616
NOTE
2-9