Removing The Air Plenum - Kodak X-Omat 480 RA Service Manual

Removing the Air Plenum

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-7. In
addition, the RECEIVING-END and
NON-DRIVE SIDE ACCESS PANELS
must be removed from the processor.
See pages 1-3 through 1-5 for
instructions, if necessary.
If the DRIVE SIDE of the processor is
against the WALL, use a small
OFFSET SCREWDRIVER TL-1611
and a SCREWDRIVER with HOLDER
TL-1194 to do this procedure.
[1] Remove:
• SCREWS
• THERMISTOR and CABLING
• AIR PLENUM.
[2] Disconnect CONNECTOR P/J 17 at the
ELECTRICAL BOX.
[3] Install all parts removed in previous steps.
When installing the THERMISTOR, use
SILASTIC SEALANT RTV 102 TL-2191
or equivalent.
246616
NOTE
NOTE
THERMISTOR
Figure 4-6 Removing the Air Plenum
AIR
PLENUM
H108_0232CCA
H108_0232CA
4-7