Removing And Cleaning The Developer Heat Exchanger Cover - Kodak X-Omat 480 RA Service Manual

Removing and Cleaning the Developer Heat Exchanger Cover

For this procedure the processor must be deenergized, and the TOP COVER must be removed
from the processor. See pages 1-3 through 1-7 for instructions, if necessary. In addition, the
water supply to the processor must be shut off for this procedure.
[1] Remove the DETECTOR CROSSOVER ASSEMBLY and the DEVELOPER/FIXER CROSSOVER.
DEVELOPER/FIXER
CROSSOVER
DETECTOR
CROSSOVER
ASSEMBLY
[2] Remove the DEVELOPER RACK. Use the RACK DRIP TRAY to prevent contamination of the other
solutions.
7-6
IMPORTANT
WASH WATER
HOSE
Figure 7-4 Removing Crossovers
FIXER/WASH
CROSSOVER
H108_0238BCA
H108_0238BA
246616