The information contained herein is based on the experience and knowledge relating to the subject matter gained by
Eastman Kodak Company prior to publication.
No patent license is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and makes no warranty, express
or implied, with respect to this information. Kodak shall not be liable for any loss or damage, including consequential or
special damages, resulting from the use of this information, even if loss or damage is caused by Kodak's negligence or
other fault.
This equipment includes parts and assemblies sensitive to damage from electrostatic discharge. Use
caution to prevent damage during all service procedures.
Introduction........................................................................................................................................................ 1-1
Required Tools............................................................................................................................................. 1-1
Electrostatic Discharge ................................................................................................................................ 1-2
Overview of Processor................................................................................................................................. 1-3
Energizing the Processor............................................................................................................................. 1-7
Deenergizing the Processor ........................................................................................................................ 1-7
Racks .................................................................................................................................................................. 2-1
Overview of Roller Transport....................................................................................................................... 2-2
Crossover Assemblies ................................................................................................................................. 2-3
Adjusting the Side Plates............................................................................................................................. 2-3
Rack Assemblies ......................................................................................................................................... 2-4
Adjusting the Chain .............................................................................................................................. 2-4
Installing the Chain ............................................................................................................................... 2-4
Turnaround Assembly .................................................................................................................................. 2-9
B Roller ........................................................................................................................................................ 2-11
Checking the Guide Shoes................................................................................................................... 2-11
Main Drive .......................................................................................................................................................... 3-1
Dryer ................................................................................................................................................................... 4-1
Removing the Blower Assembly.................................................................................................................. 4-2
Inner Bearing ........................................................................................................................................ 4-3
2
PLEASE NOTE
Table of Contents
Page
246616