Table of Contents
Advertisement
Removing the Dryer Exhaust Fan
For this procedure the processor must be deenergized. See page 1-7. In addition, the DRIVE
SIDE ACCESS PANEL and the RECEIVING-END ACCESS PANEL must be removed from the
processor. See pages 1-3 through 1-5 for instructions, if necessary.
[1]
Disconnect CONNECTOR P/J 4.
[2]
Remove the EXHAUST HOSE from the FAN BODY.
[3]
Loosen the 2 SCREWS from the FAN SUPPORT.
[4]
Remove the FAN ASSEMBLY from the processor.
[5]
Install the new FAN ASSEMBLY.
[6]
Install all parts removed in previous steps and make any necessary connections.
FAN SUPPORT
FAN BODY
SCREW (2)
246616
IMPORTANT
Figure 4-12 Removing the Fan Support Screws
HOSE CLAMP
EXHAUST HOSE
H108_0026DCB
H108_0026DA
4-13
Advertisement
Table of Contents
