Table of Contents
Advertisement
Removing the 200 Circuit Board Assembly
[1]
Move the WALL POWER SWITCH to the ''OFF'' position.
[2]
Attach the MAGNETIC POWER WARNING SIGN, TL-1926, to the wall power switch indicating that the
processor is being serviced.
[3]
If necessary, disconnect P/J204.
[4]
Remove the 4 SCREWS that hold the CONTROL PANEL. See Figure 6-11.
• Possible damage from electrostatic discharge.
• Prevent damage to the wires and components.
[5]
Remove the CONTROL PANEL from the processor.
[6]
Disconnect CONNECTOR P/J201, P/J202, and P/J203.
[7]
Remove the 2 plastic SCREWS and 2 plastic WASHERS.
[8]
Remove the 2 JACK SCREWS from the PIC CONNECTOR P204.
[9]
Remove the 200 CIRCUIT BOARD ASSEMBLY.
[10]
Reverse the procedure to install a new 200 CIRCUIT BOARD ASSEMBLY.
246616
Dangerous Voltage
6-13
Advertisement
Table of Contents
