Resilient Pressure Drive Roller (Wash Rack)
Removing and Installing the Drive Roller
[1]
Remove the following:
• TIE ROD SHAFTS
• SCREWS, GEAR, SPACERS, and BEARINGS from the outside
of both SIDE PLATES. See figure 2-7.
[2]
Rotate the KEYWAY to the up position.
[3]
Pull the ROLLER to the non-drive side and remove the KEY from the SPROCKET.
[4]
Remove the 2 SPRINGS.
[5]
Pull the ROLLER to the drive side. Flex the SIDE PLATE to allow removal of the ROLLER.
[6]
Reverse the procedure to assemble.
246616
2-7