Removing Circuit Breaker Cb1; Removing Safelight Receptacle J1 - Kodak X-Omat 480 RA Service Manual

Removing Circuit Breaker CB1

[1] Move the WALL POWER SWITCH to the ''OFF'' position.
[2] Attach the MAGNETIC POWER WARNING SIGN, TL-1926, to the wall power switch indicating that the
processor is being serviced.
[3] Remove the 4 SCREWS that hold the CONTROL PANEL. See Figure 6-10.
[4] Remove the CONTROL PANEL from the processor.
[5] Disconnect and label the 8 wires connected to CIRCUIT BREAKER CB1.
[6] Remove the 4 SCREWS that hold CIRCUIT BREAKER CB1.
[7] Remove CIRCUIT BREAKER CB1.
[8] Reverse the procedure to install a new CIRCUIT BREAKER CB1.

Removing Safelight Receptacle J1

[1] Move the WALL POWER SWITCH to the ''OFF'' position.
[2] Remove the 4 SCREWS that hold the CONTROL PANEL. See Figure 6-10.
[3] Remove the CONTROL PANEL from the processor.
[4] Disconnect and label the 3 wires connected to SAFELIGHT RECEPTACLE J1.
[5] Hold and press the LOCKING TABS to remove the SAFELIGHT RECEPTACLE J1 from the PLATE.
[6] Reverse the procedure to install a new SAFELIGHT RECEPTACLE J1.
246616
Dangerous Voltage
Prevent damage to the wires and components.
Dangerous Voltage
Prevent damage to the wires and components.
6-11