Adjusting The Sprocket Alignment On The Main Drive Chain - Kodak X-Omat 480 RA Service Manual

Adjusting the Sprocket Alignment on the Main Drive Chain

For this procedure the processor must be deenergized. See page 1-7. In addition, the TOP
COVER and DRIVE SIDE ACCESS PANEL must be removed from the processor. See pages 1-3
through 1-5 for instructions, if necessary.
[1] Remove the FILTER BEZEL and the SPLASH GUARD.
[2] Loosen the SETSCREW on the MOTOR SHAFT SPROCKET. See Figure 3-1
[3] Move the MOTOR SHAFT SPROCKET into alignment with the DRIVE SHAFT SPROCKET.
[4] Tighten the SETSCREW.
Adjusting the Chain Tension
[5] Loosen the 2 MOTOR MOUNTING BOLTS.
Check the tension of the MOTOR DRIVE CHAIN between the DRIVE SHAFT SPROCKET and
the MOTOR SHAFT SPROCKET.
[6] Move the MOTOR to adjust the MOTOR DRIVE CHAIN for the correct tension. Allow a deflection of
1 1
⁄ in. to ⁄ in. (3.2 to 6.4 mm).
8 4
Lubricating the Chain
[7] Check that the MOTOR DRIVE CHAIN is lubricated.
• If the MOTOR DRIVE CHAIN is dry, apply lubricant to the CHAIN. Use NLG1-No. 2 Lithium Ball and
Roller Bearing Grease TL-2324.
• If the MOTOR DRIVE CHAIN is rusty, remove the CHAIN and install a new MOTOR DRIVE CHAIN.
3-2
Do not make the MOTOR DRIVE CHAIN too tight.
Do not allow the DRIVE CHAIN to operate without lubrication.
IMPORTANT
IMPORTANT
NOTE
246616