Network Settings; Figure 2-50. Communications Configuration, Network Settings; Table 2-14. Lan/Ethernet Configuration Properties - Teledyne T400 User Manual

2.5.10.5

NETWORK SETTINGS

The Setup>Comm>Network Settings menu is for Ethernet configuration. The address
settings default to automatic configuration by Dynamic Host Configuration Protocol
(DHCP). Most users will want to configure the instrument with a static IP address: click
the Static radio button to manually assign a static IP address (consult your network
administrator, and see Table 2-16 for information).

Figure 2-50. Communications Configuration, Network Settings

PROPERTY
IP address
Subnet Mask
Default
Gateway
78
Table 2-16. LAN/Ethernet Configuration Properties
A string of four packets of 1 to 3 numbers each (e.g. 192.168.76.55.) is the
internet protocol address of the instrument itself.
A string of four packets of 1 to 3 numbers each (e.g. 255.255.252.0) number that
masks an IP address, and divides the IP address into network address and host
address and identifies the LAN to which the device is connected. All addressable
devices and computers on a LAN must have the same subnet mask. Any
transmissions sent to devices with different subnets are assumed to be outside
of the LAN and are routed through the gateway computer onto the Internet.
A string of numbers very similar to the Instrument IP address (e.g.
192.168.76.1.) that is the address of the computer used by your LAN and serves
as a router to access the Internet or another network.
Teledyne API – Model T400 O
DESCRIPTION
Analyzer 083730400A DCN8130
3