Table 4-13: Lan/Internet Configuration Properties - Teledyne T200H User Manual

Teledyne API - Model T200H/T200M Operation Manual
PROPERTY
DHCP STATUS
INSTRUMENT
IP ADDRESS
GATEWAY IP
ADDRESS
SUBNET MASK
1
TCP PORT
HOST NAME
1
Do not change the setting for this property unless instructed to do so by Teledyne API
Technical Support personnel.
Note
07270D DCN7141

Table 4-13: LAN/Internet Configuration Properties

DEFAULT STATE
On
Configured by
disabled when
DHCP
DHCP is ON
Configured by
disabled when
DHCP
DHCP is ON
Configured by
disabled when
DHCP
DHCP is ON
3000
[initially blank]
It is recommended that you check these settings the first time you power up your
analyzer after it has been physically connected to the LAN/Internet to confirm that
the DHCP server has successfully downloaded the appropriate information from
you network. If the gateway IP, instrument IP and subnet mask are all zeroes (e.g.
"0.0.0.0"), the DHCP was not successful. It may be necessary to manually
configure the analyzer's Ethernet properties. Consult your network administrator.
This displays whether the DHCP is
turned ON or OFF.
Editable
EDIT key
This string of four packets of 1 to 3
numbers each (e.g. 192.168.76.55.) is
the address of the analyzer itself.
A string of numbers very similar to the
EDIT key Instrument IP address (e.g.
192.168.76.1.)that is the address of
the computer used by your LAN to
access the Internet.
Also a string of four packets of 1 to 3
numbers each (e.g. 255.255.252.0)
that defines that identifies the LAN the
device is connected to.
EDIT key
All addressable devices and
computers on a LAN must have the
same subnet mask. Any transmissions
sent devices with different assumed to
be outside of the LAN and are routed
through gateway computer onto the
Internet.
This number defines the terminal
control port by which the instrument is
Editable addressed by terminal emulation
software, such as Internet or Teledyne
API's APICOM.
The name by which your analyzer will
appear when addressed from other
computers on the LAN or via the
Editable Internet. While the default setting for
all Teledyne API analyzers is the
model number, the host name may be
changed to fit customer needs.
Operating Instructions
DESCRIPTION
111