Table 2-7: Ethernet Status Indicators; Table 2-8: Lan/Internet Configuration Properties - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual
The card has four LEDs that are visible on the rear panel of the analyzer, indicating
its current operating status.
LNK (green)
ACT (yellow)
TxD (green)
RxD (yellow)
This option can be installed in conjunction with the RS-232 multidrop (option 62)
allowing the instrument to communicate on both types of networks simultaneously.
6.9.8.1. Ethernet Card COM2 Communication Modes and
The COM2 baud rate and communication modes for the COM2 are automatically set
when the Ethernet option is enabled. The baud rate is automatically set at 115 200
kBaud.
6.9.8.2. Configuring the Ethernet Interface Option using
The Ethernet option uses Dynamic Host Configuration Protocol (DHCP) to
automatically configure its interface with your LAN. This requires your network
servers also be running DHCP. The analyzer will do this the first time you turn the
instrument on after it has been physically connected to your network. Once the
instrument is connected and turned on it will appear as an active device on your
network without any extra set up steps or lengthy procedures.
Should you need to, the following Ethernet configuration properties are viewable via
the analyzer's front panel.
PROPERTY
DHCP
STATUS
INSTRUMENT
IP ADDRESS
P/N 04316 Rev: B

Table 2-7: Ethernet Status Indicators

LED
ON when connection to the LAN is valid.
Flickers on any activity on the LAN.
Flickers when the RS-232 port is
transmitting data.
Flickers when the RS-232 port is
receiving data.
Baud Rate
DHCP

Table 2-8: LAN/Internet Configuration Properties

DEFAULT STATE
On
EDIT key
Configured
by DHCP
when DHCP
FUNCTION
This displays whether the DHCP is
turned ON or OFF.
Editable
This string of four packets of 1 to 3
disabled
numbers each (e.g. 192.168.76.55.) is
the address of the analyzer itself.
is ON
Operating Instructions
DESCRIPTION
127