How To Install The Pump And Bell Housing Assembly - Genie S-65 XC Service And Repair Manual

September 2018
How to i nstall the Pump and Bell H ousing Ass embl y
How to Install the Pump and Bell
Housing Assembly
1 Install the pump and bell housing assembly.
Deutz models: Torque the bell housing
mounting bolts labeled "C" in sequence to
28 ft-lbs / 38 Nm. Then torque the bell housing
mounting bolts labeled "C" in sequence to
40 ft-lbs / 54 Nm.
Ford models: Torque the bell housing
mounting bolts labeled "A" and "B" in
sequence to 28 ft-lbs / 38 Nm and the
mounting bolts labeled "C" to 49 ft-lbs / 66 Nm.
Then torque the bell housing mounting bolts
labeled "A" and "B" in sequence to 40 ft-lbs /
54 Nm and the mounting bolts labeled "C" to
70 ft-lbs / 95 Nm.
Perkins models: Torque the bell housing
mounting bolts labeled "B" in sequence to
28 ft-lbs / 38 Nm and the mounting bolts
labeled "A" to 49 ft-lbs / 66 Nm. Then torque
the bell housing mounting bolts labeled "B" in
sequence to 40 ft-lbs / 54 Nm and the
mounting bolts labeled "A" to 70 ft-lbs / 95 Nm.
Component damage hazard.
When installing the pump, do not
force the pump coupler into the
flexplate or damage to the pump
shaft seal may occur.
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
Part No. 1288652GT
Deutz Models D2011L03i, TD2011L04i
® ™ ® ™
S -60 XC • S -65 XC
Service and Repair Manual
Ford Models
Deutz Models D 2.9 L4, TD 2.9 L4
Engines
69